A snow-covered brick house at night with one illuminated upstairs window during a heavy snowstorm.

HVAC Installation in Morristown, TN

A new system here will heat from October through April and cool from May through September every year. Tell us about the house, and a licensed contractor who covers Hamblen County will get in touch.

Tell us about the job

It takes about a minute.

Step 1 of 3: Equipment
A gas furnace and sheet-metal air handler unit installed in an unfinished concrete basement.

What a new system in Morristown has to handle

Your new system needs to run in both directions here. Winter nights average 30°F from December through February, and summer afternoons average 86°F, so whatever you install has to hold up on both ends. There's no real off season either. Heat runs October through April, seven months, and cooling picks up May through September, another five. That's the full year.

Most homes in Hamblen County heat with electricity, so the furnace or heat pump you choose is doing real work every cold month, not backing up a gas line. Storms are part of the picture too. Tennessee saw 20 percent of households go at least 24 hours without power in 2024, and this area has logged 19 winter storms and 59 damaging wind events over the past ten years. A system that depends on the grid to restart is worth asking about before it goes in, not after the power comes back on.

7 months
October through April, your system heats
5 months
May through September, it cools
30°F
the average winter night it heats against
86°F
the average summer afternoon it cools against
Isometric cutaway illustration of a single-story house showing interior rooms with furniture, ductwork and piping running to a tall vertical flue through the dark shingled roof, and a furnace-like appliance unit on the floor.
Your system heats October through April and cools May through September.

NOAA nClimDiv, 1991–2020 normals

When should I replace my HVAC system?
Replace it when repairs keep coming back, the unit is old, or it can no longer keep up on the coldest nights or hottest afternoons. A failing part on an old furnace or air conditioner is often a sign that other parts are close behind, and at some point another repair stops making sense. Homes here need heat from October through April and cooling from May through September, so there is no real off season to put it off. If a contractor tells you the same repair keeps happening, that is usually the point to plan a replacement instead.
Should I replace my furnace and air conditioner at the same time?
If they are close in age, replacing them together often makes sense, but it depends on the condition of each one. A furnace and air conditioner installed at the same time tend to wear out around the same time too, so if one is failing the other may not be far behind. They also share a blower and, in many systems, a coil, so replacing one can affect how the other performs. A contractor can look at both and tell you honestly whether the second one has real life left in it.
What happens during an HVAC installation?
A contractor removes the old equipment, sets the new furnace or air conditioner in place, and connects it to the ductwork, refrigerant lines, gas or electrical supply, and thermostat. They check that the ducts are sized right for the new unit, since a mismatch there hurts performance no matter how good the equipment is. Once it is running, they test it, measure airflow and refrigerant charge, and confirm the thermostat is controlling it correctly. Homes here run heat or cooling all 12 months of the year between the two seasons, so getting this right the first time matters.